To Next PageTo Next Page
Need help?Do you have a question about the Bosch 1347A and is the answer not in the manual?
General| Cord Length | 8 ft |
|---|---|
| No Load RPM | 11, 000 |
| Rating | 120V |
| No Load Speed | 11, 000 RPM |
| Arbor Size | 5/8 in |
| Wheel Diameter | 4-1/2 in |
| Width | 2.5 in |
| Spindle Thread | 5/8 in.-11 UNC |
| Amperage | 7.5 A |
Maintain a clean, well-lit work area and keep bystanders away for safety.
Ensure proper grounding, avoid wet conditions, and use correct plugs.
Stay alert, dress properly, avoid accidental starting, and use safety equipment.
Use the correct tool, maintain it properly, secure the workpiece, and avoid misuse.
Tool service must be performed by qualified repair personnel using identical replacement parts.
Always use the proper guard and ensure accessories are rated for the tool's speed.
Hold tool with insulated surfaces, use auxiliary handle, and inspect wheels before use.
Handle wheels carefully to avoid chipping or cracking; replace if dropped.
Use correct wheel size/type, avoid improper discs, and clean vents regularly.
Avoid bouncing, snagging, and working near flammables; position cord safely.
Use caution with treated lumber, lead paint, and wear respirators for dust.
Attach wheel guard securely to spindle neck before grinding.
Use correct lock nut/backing flange for accessories; thread onto spindle.
Thread side handle into housing for balance and control.
Use diamond wheel with guard for masonry; avoid cooling fluids during cutting.
Install backing pad and sanding disc, ensuring safe operating speed.
Thread wire brush onto spindle, ensuring it seats against the shoulder.
Operate the slide switch for ON/OFF functions and locking.
Features soft start and maintains constant speed under load.
Select appropriate wheels and maintain a 10-15 degree angle for efficient grinding.
Choose grit and disc type based on material; tilt disc at 10-15 degrees.
Select grit from 16 (coarse) to 180 (fine) for best results.
Use crosswise strokes, avoid holding in one spot, and use tool weight for pressure.
Align disc motion with grain; use finer grit for smoother finish.
Clean metal, use coarse grit for heavy duty, then medium and fine grits.
Use wire brushes for cleaning; avoid bouncing and snagging.
Service by authorized personnel; replace noisy bearings to prevent motor failure.
Tool is pre-lubricated; regrease gears with special lubricant at brush changes.
Examine brushes every 2-6 months for peak efficiency; use genuine Bosch replacements.
Disconnect tool before cleaning; use compressed air and wear safety goggles.
Use adequately sized, grounded 3-wire extension cords to prevent issues.
Lists standard accessories like wheel guard, side handle, lock nut, and backing flange.
Lists optional accessories such as carrying cases.
