Bosch 13P User Manual

9 708 069 951 Page1
Installation / Operating Instructions
GOOD.BEETER>BOSCH
BOSCH 13P & 16P
Continuous Flow Gas Water Heater
1 Main Cover 5 Cold Water Inlet
2 Inspection Window 6 Hot Water Supply
3 Access Panel 7 Mounting Point
4 Gas Inlet 8 Horizontal Flue
A-D Dimensions on page 2 Fig 3
Fig. 1
This appliance must be installed in accordance with the manufacturer’s installation instructions,
AG 601, NZ 5261, AS/NZS 3500.4.2
and all Local Water, Building and Gas fitting regulations
To be installed and serviced only by an authorised person
This appliance is not suitable for use as a pool heater
The “authorised installing person” is responsible for :
1. Correct commissioning of this appliance.
2. Ensure unit performs to the specifications stated on the rating label.
3.. Demonstrate operation of unit to customer before leaving.
4. Hand these instructions to customer.
Failure to install this appliance in accordance with these installation instructions may
void warranty
In the interest of continued product improvement, Bosch reserves ther right to alter the specifications
without notice.
25/10/2011

Bosch 13P Specifications

General

Brand	Bosch
Model	13P
Flow Rate	3.2 GPM
Fuel Type	Propane
Type	Tankless
Ignition Type	Electronic
Voltage	120V
Temperature Range	85°F to 140°F

Summary

Installation and Operating Instructions

Authorized Installation and Servicing

Ensures the appliance is installed and serviced exclusively by qualified personnel.

Installation Compliance and Warranty

Installation Guidelines

Appliance Operating Instructions

Initial Appliance Commissioning

Step-by-step guide for the initial lighting and commissioning process of the water heater.

Critical Safety Warnings

Highlights potential hazards like pilot light issues, operational faults, and necessary immediate actions.

Commissioning: Water Flow Adjustment

Water Flow Rate Adjustment

Procedure to adjust the water flow rate for optimal heating performance based on ambient temperature.

Commissioning: Pressure Adjustments

Burner Pressure Adjustment Procedure

Details how to adjust burner pressure using a manometer and test point for correct combustion.

Thermostat Setting and Calibration

Thermostat Calibration: Water Flow

Adjusting water flow rate as a step in calibrating the thermostat for accurate temperature control.

Thermostat Calibration: Burner Pressure

Setting correct burner pressure, referencing gas inlet pressure, as part of thermostat calibration.

Thermostat Calibration: Temperature Verification

Measuring and adjusting outlet water temperature to 60°C, checking flow rate impact.

Thermostat Calibration: Final Check

Product Warranty Information

Warranty Coverage Periods

Conditions Voiding Warranty

Warranty Claim Requirements

Warranty Claims and Bosch Contact

How to Lodge a Warranty Claim