25
B O S C H
ENGLISH
* Model dependent
Trouble shooting
Problem Possible causes Solution
The iron begins
to smoke when
switched on.
1. During rst use: certain
components on the
appliance have been lightly
greased at the factory and
may produce a small
amount of smoke when
initially heated.
1. This is completely normal
and will stop after a short
while.
The iron does not
produce any
steam.
1. During rst use, water has
not lled the hose (8)
completely.
2. The “Calc'nClean” indicator
light (6) will ash. The
descaling process has not
been completed.
1. Press and hold the steam
release button (17) pressed
until steam comes out.
2. Perform a cleaning cycle
(see the “Descaling process"
section).
Dirt comes out
through the
soleplate.
1. There is a build up of
limescale or minerals in the
iron.
2. Chemical products or
additives have been used.
1. Carry out a cleaning cycle
(see the “Descaling process"
section).
2. Never add products to the
water (see the “Filling the
water tank” section).
Clean the soleplate with a
damp cloth.
The
“Calc'nClean”
indicator light (6)
does not turn off.
1.
The iron
descaling process
has been stopped before
being completed.
1.
Restart and complete the
iron descaling process.
The appliance
makes a pumping
sound.
1. Water is being pumped into
the iron.
2. The water tank is empty.
1. This is normal.
2. Fill the water tank.
The iron drips. 1. Ironing programme selection
knob (16) is in “i-Temp”
mode and the “high steam”
indicator light (2) lights up
permanently.
1. When you iron in “i-Temp”
mode, press “Set” button (1)
until the “medium steam”
indicator light (3) lights up.
(See the "ironing
programmes" section).
The iron
produces little
steam.
1. The iron has been switched
on recently.
1. It is normal, the iron
produces steam gradually
until it is stabilized.
If the above tips do not solve the problem, get in touch
with our customer service.
You can download this manual from the Bosch local
homepages.
To Next Page
Loading...
Need help?
General
