Bosch 6 Series - Operational Safety: Cooling, Water, and Physical Hazards; Cooling Cycle and Heat Dissipation Procedures; Condensate Water and Cleaning Agent Safety; Appliance Door and Worktop Stability

en
10
Changing the door
handle
(if required)
Fig. 2
Change the door handle in numerical
sequence.
Fitting the wall spacer
Fig. 3
If available:
Fit wall spacers to obtain the indicated
energy absorption of the appliance.
A reduced wall gap will not restrict
the function of the appliance. The energy
absorption may then change slightly.
Aligning the appliance
Place the appliance in the designated
location and align. The appliance must
be level. If the floor is uneven, use
the front height-adjustable feet. Adjust
the height-adjustable feet with a wrench.
Note
The appliance must be upright. Please
align it with a spirit level.