English–4
Bosch eBike Systems 1 270 020 XBP | (22.5.17)
Error Code Indication
The components of the eBike system are continuously and
automatically monitored. If an error is detected, the corre-
sponding error code will appear in the speed indication a.
Depending on the type of error, the drive unit is automatically
shut off, if required. Continued travel without assistance from
the drive unit is possible at any time. However, have the eBike
checked before attempting new trips.
f Have all repairs performed only by an authorised bike
dealer.
Code Cause Corrective Measure
410
One or more buttons of the on-board
computer are blocked.
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
414 Connection problem of the operating
unit
Have connections and contacts checked.
418
One or more buttons of the operating
unit are blocked.
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
419
Configuration error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
422
Connection problem of the drive unit Have connections and contacts checked.
423 Connection problem of the eBike
battery pack
Have connections and contacts checked.
424 Communication error among the
components
Have connections and contacts checked.
426
Internal time-out error Restart the system. If the problem persists, contact your Bosch eBike
dealer. In this error status, it is not possible to display or adjust the wheel
circumference in the basic settings menu.
430 Internal battery pack of the on-board
computer is empty.
Charge the on-board computer (in the holder or via the USB port).
431
Software version error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
440 Internal error of the drive unit Restart the system. If the problem persists, contact your Bosch eBike
dealer.
450
Internal software error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
460
Error at USB connection Remove the cable from the USB connection of the on-board computer. If
the problem persists, contact your Bosch eBike dealer.
490 Internal error of the on-board
computer
Have the on-board computer checked.
500
Internal error of the drive unit Restart the system. If the problem persists, contact your Bosch eBike
dealer.
502
Bike lighting error Check the light and the associated wiring. Restart the system. If the
problem persists, contact your Bosch eBike dealer.
503
Error of the speed sensor Restart the system. If the problem persists, contact your Bosch eBike
dealer.
510
Internal sensor error Restart the system. If the problem persists, contact your Bosch eBike
dealer.
511
Internal error of the drive unit Restart the system. If the problem persists, contact your Bosch eBike
dealer.
530
Battery pack error Switch off the eBike, remove the eBike battery pack and reinsert the
eBike battery pack. Restart the system. If the problem persists, contact
your Bosch eBike dealer.
OBJ_BUCH-2819-002.book Page 4 Monday, May 22, 2017 11:27 AM
To Next Page
Loading...
Need help?
General
