English – 38
1 270 020 Wen | (13.5.16) Bosch eBike Systems
eShift with SRAM DD3 Pulse
The hub gear of the SRAM DD3 Pulse works on a speed-dependent basis.
Regardless of which gear is engaged on the derailleur gears, one of the
three gears of the gear hub will automatically be engaged.
It is also possible to use the “ – ” or “+” button to shift gear manually here.
Automatic mode is activated automatically if you press the “ – ” button in
first gear. If you press the “ – ” or “+” button in automatic mode, the mode
changes back to manual mode. In automatic mode, only “A” is ever shown
in the gear display. If the gear is shifted in automatic mode, the gear is not
shown on the display.
If you are not in automatic mode, the engaged gear will be shown briefly on
the display whenever the gear of the hub gear is shifted.
The drive unit recognises the gear shift and briefly reduces the motor assis-
tance level as a result of it, which means the gear can also be shifted at any
time under load or on a hill.
If the eBike is brought to a stop from a speed of more than 10 km/h, the
system may automatically shift down a gear to a set “Starting gear”. The
“Starting gear” can be set under “My eBike”> “eShift (SRAM)”.
eShift with Shimano Di2
For Shimano eShift you use the Shimano control lever to shift gears.
The gear is always displayed in the eShift field. The gear is displayed briefly
during a gear shift only when the eShift field is not visible (e.g. in settings).
The drive unit recognises the gear shift and briefly reduces the motor assis-
tance level as a result of it, which means the gear can also be shifted at any
time under load or on a hill.
If the eBike is brought to a stop from a speed of more than 10 km/h, the
system may automatically shift down a gear to a set “Starting gear”. The
“Starting gear” can be set under “My eBike”> “eShift (Shimano)”.
To Next Page
Loading...
Need help?
General
