English – 36
1 270 020 Wen | (13.5.16) Bosch eBike Systems
Switching the Push-assistance mode On/Off
The push-assistance feature makes it easier to push the eBike. The speed
in this function depends on the set gear and cannot exceed 6 km/h (max.).
The lower the set gear, the lower the speed in the push-assistance function
(at full output).
The push-assistance function may only be used when pushing the
eBike. Danger of injury when the wheels of the eBike do not have
ground contact while using the push-assistance function.
To activate the push-assistance function, briefly press button “WALK” on
your on-board computer. After activation, press button “+” within 3 s and
keep it pressed. The eBike drive is switched on.
The push assistance is switched off as soon as one of the following occurs:
– You release button “+” 14,
– The wheels of the eBike are blocked (e.g. by actuating the brakes or
impacting against an obstacle),
– The speed exceeds 6 km/h.
After releasing the “+” button, the push assistance remains on standby for
another three seconds. Pressing the “+” button again within this period
will reactivate the push assistance.
Note: On some systems the push-assistance function can be started
directly by pressing the “WALK” button.
Note: The push assistance cannot be activated in the “OFF” assistance
level.
Switching bike lights on/off
In the model, in which the lighting is powered by the eBike system, the
front and rear light can be switched on and off at the same time via the
on-board computer with the button 6.
The illumination symbol s1 is displayed when the light is on.
Switching the bike light on and off has no effect on the back lighting of the
display.
To Next Page
Loading...
Need help?
General
