What to do if my Bosch Pressure Washer motor starts but has no pressure?
If your Bosch Pressure Washer motor starts but there's restricted or no working pressure, try the following: * Connect the water supply. * Clean the water filter, as it might be clogged. * Clean the nozzle, as it might also be clogged.
What to do if my Bosch Advanced Aquatak 160 Pressure Washer motor starts but there is no pressure?
If your Bosch Pressure Washer motor starts but there's no pressure, try cleaning the nozzle, as it might be partly blocked.
How to fix a Bosch Advanced Aquatak 160 Pressure Washer when the motor refuses to start?
If your Bosch Pressure Washer's motor refuses to start, here are a few things to check: * Ensure the plug is properly connected. * Try a different mains socket to rule out a faulty one. * Replace the fuse if it's faulty or blown. * Remove any extension cables to see if they are the issue. * Let the motor cool down for 15 minutes in case the motor protector has activated. * If it's frozen, allow the pump, water supply hose, or accessory to thaw.
Why is the pressure pulsating on my Bosch Pressure Washer and how to fix it?
If the pressure from your Bosch Pressure Washer is pulsating, here's what you can do: * Run the pressure washer with the spray handle open and the nozzle at low pressure until you achieve a consistent working pressure. This will remove any air in the inlet water supply. * Ensure your water supply meets the specifications, with a minimum hose diameter of 1/2" or 13 mm. * Clean the water filter. * Straighten any kinks in the water supply hoses. * If you're using a high-pressure extension hose, remove it and retry. The maximum length for an extension hose is 7 meters.
Why does my Bosch Pressure Washer motor keep stopping?
If your Bosch Pressure Washer motor stops, check the following: * Replace the fuse if it's faulty or blown. * Ensure the mains voltage matches the specifications on the model tag. * Allow the motor to cool down for 15 minutes if the motor protector has activated.
Why does my Bosch Pressure Washer motor sound like it's starting but won't?
If your Bosch Pressure Washer motor sounds like it's starting but fails to fully start, check these: * Make sure the voltage of the mains power supply line is the same as that on the plate. * Check the characteristics of the extension cable if you are using one, as voltage loss may occur.
What causes my Bosch Advanced Aquatak 160 Pressure Washer to keep blowing fuses?
To address blown fuses in your Bosch Pressure Washer, change to a mains supply higher than the pressure washer amp consumption if the fuses are incorrectly rated.
Why is water leaking from my Bosch Advanced Aquatak 160 Pressure Washer?
A slight water leak from your Bosch Pressure Washer is permissible. However, if the leak is excessive due to a leaking pump, contact the Bosch Service Centre.
General| Brand | Bosch |
|---|---|
| Model | Advanced Aquatak 160 |
| Category | Pressure Washer |
| Language | English |
To Next Page