Need help?Do you have a question about the Bosch Aquatak Clic 130 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | Aquatak Clic 130 |
| Category | Pressure Washer |
| Language | English |
Read instructions, follow general safety regulations, and heed warning signs for safe operation.
Ensure correct voltage, use RCD protection, handle cables carefully, and avoid damaged parts.
Follow water regulations, use sealed joints, and ensure high-pressure hoses are not damaged.
Check unit condition, avoid directing jet at people, and refrain from using hazardous liquids.
Use unit per regulations, ensure supervision, and never leave it unattended when switched on.
Operated by authorized persons; not for those with reduced capabilities without supervision.
Hold gun and spray lance firmly with both hands due to recoil from the high-pressure nozzle.
Switch off the motor and secure the unit properly before transporting it.
Turn off power before maintenance. Repairs must be done by authorized Bosch Service Centres.
Only use Bosch-approved accessories and spare parts for safe and reliable operation.
For cleaning outdoor areas, tools, vehicles, and boats within 0-40°C; not for professional use.
Verify all listed items are present upon unpacking, including power washer, gun, lance, and accessories.
Component numbering corresponds to the main illustration for easy reference.
Table detailing article numbers, power, pressure, flow rate, hose length, and weight for different models.
Provides measured sound pressure/power levels and vibration emission values with uncertainty.
Statement of compliance with EN 60335 and EC directives 2004/108/EC, 2006/42/EC, 2000/14/EC.
Switch off power, disconnect plug before any adjustments, cleaning, or if cable is damaged.
Understand voltage needs (230V/220V/240V) and earth connection requirements for different models.
Use correct cable dimensions, watertight plugs, RCDs (30mA), and handle plugs with care.
Assemble handle, holder, detergent tank, connect gun, lance, and hoses as per diagrams.
Select spray mode (low pressure fan, high pressure fan, roto jet, pencil jet) by rotating the nozzle.
Use only Bosch detergents, fill tank with diluted solution, and spray in low pressure fan mode.
Detach 4 jet-lance, insert and lock flexi-jet-lance into power gun for use.
Ensure horizontal position, connect power/water, press on/off switch, and use trigger safety lock.
Motor switches off when trigger is released, reducing pressure and saving energy.
Release trigger, engage safety lock, press off switch, close tap, and disconnect power/water.
Can draw water from sources other than taps; use filter, ensure water source is below machine.
Ensure unit is level, protect hose from damage, and avoid using roto jet on motor vehicles.
Guide to diagnosing and correcting issues like motor not starting or stopping unexpectedly.
Addresses problems like fuses blowing, pressure pulsation, low pressure, and leaks.
Ensure covers are intact, perform regular checks for defects, and carry out maintenance.
Locate, remove, rinse, and replace the water inlet strainer; never operate without it.
Clean exterior, remove all debris, and store in a frost-free room to prevent damage.
Sort for environmentally-friendly recycling; do not dispose of in household waste.
Get assistance for maintenance, repairs, and spare parts; find information on www.bosch-garden.com.
Provides contact details for service centers in Great Britain, Ireland, Australia, NZ, and South Africa.
To Next Page