22 | English
1 609 92A 3B0 | (8.3.17) Bosch Power Tools
Inserting (see figure A)
Place the application tool/accessory on a flat surface. It must
be possible to read the marking on the application tool from
above.
Turn the application tool to a position which is convenient for
the job at hand. Twelve positions displaced by 30° are possi-
ble for this.
Press the power tool onto the application tool at the required
angle until it audibly engages.
Check the tight seating of the application tool/acces-
sory. Incorrect or not securely fastened application tools/
accessories can come loose during operation and pose a
hazard.
BIM serrated seg-
ment saw blade
Insulation material,
Insulation panels,
Floor panels,
Sound-dampening floor
panels,
Cardboard,
Carpets,
Rubber,
Leather
Precise cutting of soft materials;
example: cutting insulation panels to size, flush cutting
protruding insulation material to length
HM-Riff sanding
finger
Wood,
Paint
Sanding wood or paint in hard to reach areas without
sanding paper;
example: sanding off paint between shutter louvres,
sanding wooden floors in corners
HM-Riff plunge cut
saw blade
Fibreglass,
Mortar,
Wood
Plunge cuts in severely abrasive materials;
example: routing thin mosaic tiles
HCS universal
joint cutter
Expansion joints,
Putty,
Insulation materials
(rock wool)
Cutting and separating soft materials;
example: cutting silicone expansion joints or putty
BIM plunge cut
saw blade, wood
and metal
Softwood,
Hardwood,
Veneered panels,
Plastic-laminated panels,
Non-hardened nails and
screws
Fast, deep plunge cuts in wood and metal;
example: quick cutting of wood containing nails, deep
plunge cuts in laminated panels and precise shortening of
door frames
TC plunge cut saw
blade, metal
Stainless steel (Inox),
Screws and nails,
Epoxy resin,
Glass fibre reinforced
plastics,
Fibreglass,
Plasterboard,
Porous concrete
Fast, deep plunge cuts in severely abrasive materials or
metal;
example: fast cutting of kitchen front covers, easy cutting
through hardened screws, nails and stainless steel
BIM plunge cut
saw blade, wood
and metal
Wood,
Abrasive wooden
materials,
Plastics,
Hardened nails and
screws,
Non-ferrous metal pipes
Fast, deep plunge cuts in wood, abrasive wooden materials
and plastics;
example: fast cutting of non-ferrous metal pipes and
profiles with smaller dimensions, easy cutting of non-
hardened nails, screws and steel profiles with smaller
dimensions
HCS plunge cut
saw blade, wood
Softwood,
Dowels,
Tenons,
Furniture components
Fast, deep separating and plunge cuts; also for sawing
close to edges in corners and hard to reach areas;
example: deep plunge cut in softwood for installing a
ventilation grid
Accessory Material Application
OBJ_BUCH-2966-001.book Page 22 Wednesday, March 8, 2017 9:58 AM
To Next Page
Loading...
Need help?
General
