To Next PageTo Next Page
Need help?Do you have a question about the Bosch AdvancedMulti 18 and is the answer not in the manual?
General| Voltage | 18 V |
|---|---|
| Max torque | 1.8 Nm |
| Oscillation angle left/right | 2.8 ° |
| Battery type | Lithium-ion |
| Chuck type | chuck |
| No-load speed (oscillating) | 20, 000 opm |
Read all safety warnings and instructions. Failure to follow may result in electric shock, fire, or injury.
Keep work area clean and well lit. Do not operate in explosive atmospheres. Keep children and bystanders away.
Match plugs to outlets. Avoid contact with earthed surfaces. Do not expose to rain or wet conditions.
Stay alert, use common sense, wear PPE. Prevent unintentional starting. Do not overreach. Dress properly.
Do not force the tool. Ensure the switch works. Disconnect power before adjustments. Store idle tools properly.
Hold by insulated surfaces when accessory may contact hidden wiring.
Penetration of water increases electric shock risk.
Avoid overheating. Empty dust collector. Dust can self-ignite.
Do not reach under the workpiece. Contact with saw blade can cause injury.
Contact with electric lines can lead to fire/shock. Damaging gas/water lines causes damage.
Hold firmly with both hands for secure stance and control.
For sawing/cutting wood, plastic, metal, tiles, sanding, scraping close to edges.
Lists numbered features referring to graphics page, e.g., AutoClic lever, On/Off switch, battery indicators.
Vibration values for sanding and sawing without auxiliary handle.
Vibration values for sanding and sawing with auxiliary handle.
Use specified chargers. Charge battery fully before first use. Battery protected against deep discharging.
Contact with hot accessories can cause injury.
Examples of accessories, their materials, and applications for the tool.
How to remove the battery pack with its two locking levels.
Indicator signals battery capacity or overload. Flashing red indicates overload.
How to place and secure an application tool/accessory onto the power tool.
Table detailing sanding sheet materials, applications, and grain sizes for different finishes.
Health hazards of dust. Use suitable extraction systems. Provide ventilation. Wear respirator. Prevent dust accumulation.
How to connect dust extraction for sanding. Connect hose to tool and vacuum cleaner.
How to insert the battery and switch the tool on/off. Notes on soft start and constant electronic control.
How to use the thumbwheel to set the stroke rate based on material.
Do not place the tool down before it stops completely.
Always remove the battery before maintenance or tool changes.
Use uniform pressure. Move tool back and forth to prevent overheating. Use undamaged blades. Observe material supplier recommendations.
Remove battery before work. Keep machine and slots clean. Clean accessories with wire brush. Cord replacement by Bosch.
