What to do if the cutting blade of my Bosch Brush Cutter is hot?
If the cutting blade of your Bosch Brush Cutter is getting hot, it could be because the blade is blunt. Have the blade sharpened. Another reason could be that the cutting blade has dents, have the blade inspected or overhauled. Also, it could be due to too much friction from a lack of lubricant; in this case, apply lubricant spray.
Why is my Bosch Brush Cutter not working?
If your Bosch Brush Cutter isn't operating, the battery might be discharged. Try recharging the battery. Also, make sure the safety switch is correctly activated as described in 'Initial Operation'.
Why is the cutting time per battery charge so low on my Bosch Brush Cutter?
If you're experiencing a short cutting time per battery charge with your Bosch Brush Cutter, it could be due to several reasons. There might be too much friction due to a lack of lubricant, so try applying lubricant spray. The blade may also need cleaning. Additionally, poor cutting technique can drain the battery quickly; refer to 'Working Advice' for guidance.
What to do if no charging procedure is possible for my Bosch Brush Cutter?
If you cannot charge your Bosch Brush Cutter, the battery contacts might be contaminated. Try cleaning them by inserting and removing the battery several times, or consider replacing the battery altogether if cleaning doesn't help; or the battery might be defective, then replace the battery.
Why are the blades running slow or the powertech feature not functioning on my Bosch Brush Cutter?
If the blades on your Bosch Brush Cutter are running slowly or the Powertech feature isn't working, the battery might be discharged, so recharge it. Also, if the battery was stored outside of its recommended temperature range, allow it to warm naturally to room temperature (within battery operating temperature 0 – 45 °C).
Why is the cutting blade on my Bosch Brush Cutter hot?
If the cutting blade of your Bosch Brush Cutter is getting hot, it could be because the blade is dull and needs sharpening. Alternatively, the cutting blade might have dents and require inspection or overhaul. Also, too much friction due to a lack of lubricant could be the cause, so try applying lubricant spray.
General| Brand | Bosch |
|---|---|
| Model | AHS 48LI |
| Category | Lawn and Garden Equipment |
| Language | English |
To Next Page
