EasyManua.ls Logo

Bosch Air 2000 - Installation; Installing the Filter; Operation; Air Quality Light Ring

Bosch Air 2000
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 Installation
3.1 Installing the filter
Pull the back cover and remove it from the appliance.
Pull the filter from the appliance.
Remove the plastic cover of the air purification filter.
Insert the filter back into the appliance.
Reattach the back cover.
[Figure 5 Removing the back cover]
[Figure 6 Removing the plastic cover]
[Figure 7 Inserting the filter and reattaching the back cover]
4 Operation
4.1 Understanding the air quality light ring
The light ring indicates the air quality. It lights up all colours in sequence,
when the air purifier is switched on. After approximately 30 seconds,
the particle sensor selects the color that corresponds to the surrounding
air quality of airborne particles, according to table 3.
PM2.5
PM2.5 refers to ultra-fine airborne particle pollutants smaller than 2.5
micrometers. Most of the indoor air pollutants fall under PM2.5 like:
tobacco smoke, cooking and burning candles, some airborne bacteria
and the smallest mold spores, pet allergen and dust mite allergen
particles also fall under PM2.5.
The air quality sensor scans the air continuously to detect the ultra-fine
particles. This information is reported continuously in both the digital
display and the light ring, providing real-time PM2.5 feedback.
Air quality light color Air quality level PM2.5 level
Blue Good 0-12
Purple Ok 13-35
Orange Poor 36-55
Red Bad >56
Table 3 Air quality light colors and PM2.5 levels
4.2 Switching ON/OFF
Insert the plug of the air purifier
in the power socket.
Touch
to
switch on the air purifier.
Press the
button
again,
to
switch
off the air purifier.
Note
For
optimum purification
performance,
close the doors
and the
windows.
Keep curtains away from the air inlet or air outlet.
The air purifier will operate in Auto mode by default.
4.3 Changing the mode setting
Auto-mode
In Auto-mode, the air
quality is registered in real-time, and the
appliance automatically adjusts the fan speed in accordance to
the
ambient air quality.
Manual mode
In Manual
mode, it is possible to
set the fan speed (between
Speed 1
and Speed 3). Press the button to
change to
the desired speed.
Installation
Quiet mode
In Quiet mode, the air purifier operates quietly at a low speed and all
the lights are dimmed.
Timer mode
In Timer mode, it is possible to set the timer (between 1 and 12
hours) for the equipment shut off.
5 Cleaning and maintenance
5.1 Cleaning the housing of the air purifier
Regularly clean the inside and outside of
the housing of the air purifier
to
prevent dust from collecting.
Wipe the surface with a damp
cloth.
Use a soft, dry cloth to
clean both
the interior and exterior of
the air
purifier and the air outlet.
5.2 Cleaning the particle sensor
Note:
If the air purifier is used in a dusty environment, it may need to be
cleaned
more
often.
If the humidity
level in the room
is very high,
condensation
may
develop on the air quality sensor and the air quality light may indicate
a poorer quality even
though the air quality is
good.If this
occurs,
clean the air
quality
sensor.
Clean the air quality sensor
every month for optimal functioning of
the
appliance.
Switch
off the air purifier and unplug from
the power socket.
Pull the back cover and remove it from the appliance.
Clean the particle sensor with a damp cotton swab.
Dry all parts with a dry
cotton swab.
Reattach the cover.
[Figure
8 Cleaning
the
air quality
sensor]
5.3 Cleaning the filter
CAUTION
Wear a mask and gloves when cleaning the filter surface and/or replacing
the filter.
Switch
off the air purifier and unplug it from
the power socket.
Pull the back cover and remove it from the appliance.
Pull the filter from
the appliance.
Clean the surface
of the filter with a vacuum cleaner.
Insert the filter
back
into the appliance.
Reattach the cover.
Insert the plug of the air
purifier
in the power socket.
Touch the power button
to
switch on
the appliance.
Wash your hands after cleaning the filter.
[Figure
5
Removing the back cover]
[Figure
9
Removing
and cleaning the filter]
5
Air 6000 6721880026 (2024/01)

Table of Contents

Related product manuals