Bosch AXT 25D - Technical Data; Noise;Vibration Information; Declaration of Conformity; Assembly

18 | English
F 016 L70 603 | (30.4.09) Bosch Power Tools
Technical Data
Noise/Vibration Information
Measured values determined according to
2000/14/EC (1.60 m height, 1.0 m distance
away).
Typically the A-weighted noise levels of the
product are: Sound pressure level 68 dB(A);
Guaranteed sound power level lower than
92 dB(A). Uncertainty K =3 dB.
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical data” is
in conformity with the following standards or
standardization documents: EN 60335,
EN 50434 according to the provisions of the di-
rectives 2004/108/EC, 98/37/EC (until 28 Dec
2009), 2006/42/EC (from 29 Dec 2009),
2000/14/EC.
2000/14/EC: Measured sound power level
89 dB(A). Conformity assessment procedure
according to Annex V.
Technical file at:
Bosch Lawn and Garden Ltd., PT-LG/EAE,
Stowmarket, Suffolk IP14 1EY, England
Leinfelden, 04.11.2008
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
04.11.2008
Assembly
For Your Safety
f Warning! Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the unit. Equip-
ment marked with 230 V can also be connected
to 220 V or 240 V.
Quiet-shredder AXT 22 D AXT 25 D AXT 23 TC AXT 25 TC
Article number
3600H030.. 3600H031.. 3600H032.. 3 600 H03 3..
Power consumption, S 6
(40/60 s)
1)
W 2200 2500 2300 2500
Power consumption, S 1
W 2000 2300 2100 2300
No-load speed
min
-1
40 40 40 40
Cutting system
Drum Drum Turbine Turbine
Capacity, max.
kg/h 180
2)
190
2)
215
2)
230
2)
Branch diameter, max. mm 38
2)
40
2)
42
2)
45
2)
Collection box l5353 53 53
Weight according to
EPTA-Procedure 01/2003
kg 31.3 31.3 30.5 30.5
Protection class
/I /I /I /I
1)
The S 6 operating mode (40 %) indicates a load profile of 40 s load and 60 s idle time. For practical application,
continuous operation is permitted.
2)
Depending on the hardness of the wood.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-1015-001.book Page 18 Thursday, April 30, 2009 1:08 PM