Bosch AXT 25D - Troubleshooting; Machine fails to operate; Machine beeps (also two lights on AXT 23 TC;25 TC) and does not start; One flashing light on AXT 23 TC;25 TC

English | 21
Bosch Power Tools F 016 L70 603 | (30.4.09)
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your machine
does not operate properly. If these do not identify and correct the problem, contact your service
agent.
f Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, dam-
aged or entangled.
Maintenance and Service
Maintenance and Cleaning
f Warning! Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
f Always wear protective gloves when using,
adjusting or cleaning the machine.
Note: To ensure long and reliable service, carry
out the following maintenance regularly.
Regularly check for obvious defects such as
loose, dislodged or damaged blades, loose fix-
ings, and worn or damaged components.
Problem Possible Cause Corrective Action
Machine fails to operate Collection box not fitted cor-
rectly
Fit collection box correctly
Chute assembly not fitted cor-
rectly
Fit chute assembly correctly
Mains socket faulty Use another socket
Extension cable damaged Inspect cable, replace if dam-
aged
Fuse faulty/blown Replace fuse
Machine beeps (also two lights
on AXT 23 TC/25 TC) and does
not start
Collection box/chute is not cor-
rectly assembled
Ensure the collection box is in
position
Ensure the chute assembly is in
position and clamped by turn-
ing the clamping knob (red) ful-
ly clockwise
One flashing light on
AXT 23 TC/25 TC
None, this is ok, machine is
“pluged in” and ready to use
The material to be shredded is
not pulled in
Material to be shredded is wet
and soft
Use the prodder to push the
material into the machine
Jammed material in the ma-
chine
Clear jammed material (always
wear gardening gloves)
Use the reverse button (see
“Return Motion”)
Shredded material is not com-
pletely separated and hangs to-
gether as a chain
Pressure plate requires adjust-
ment
see “Pressure Plate Adjust-
ment”
OBJ_BUCH-1015-001.book Page 21 Thursday, April 30, 2009 1:08 PM