Bosch B20CS50 Series - Page 29

28
1. “Select” button
1) Temperature control of “Magic Cool Zone” compartment
2) 4 step mode of successive temperature mode.
Initial mode by power input : “OFF”
(“Off” → “Produce” → “Meat”→ “Fish”→ “Off”)
Letters are indicated on “88” display LED
INPUT CONTROL OBJECT
CONTENTS REMARKS
1. R-Fan
2. “Magic Cool Zone” sensor
3. “SELECT” button
1. “Magic Cool Zone” damper
2. Damper heater
4-16. Temperature control of “Magic Cool Zone” compartment
2. Normal Stepping motor Control (It is linked with Refrigerator Fan (R-Fan))
3. Damper heater control
1) Damper open → Damper heater OFF
2) Damper close → Damper heater ON
4. How to check error mode (Temp. display and forced damper Open/Close)
1) How to start
Push “Select” button for 3~6 seconds.
① Initial display : “sensor temp.” display. (if sensor is normal)
“Er” display. (if sensor is disconnected or short)
② Press “Select” button 1 time : “OP” display. (forced damper open )
③ Press “Select” button 2 time : “CL” display. (forced damper close )
2) How to stop
It stops automatically in 20 sec. from the start.
5. Control way for “Magic Cool Zone” sensor error.
1) If “Magic Cool Zone” sensor is disconnected or short.
2) Damper open and close by below table. Control (Condition of “Select” button)
---OffPower input
3’rd Press
2’nd Press
1’st Press
3432 (0)Fish
5635 (2)Meat
6738 (3)Produce
Temp (℃)Temp (℃)
CloseOpen
Damper Open/Close point
Display
℉ (℃)
Mode
Each mode ON/OFF ControlOFF
Always closeON
Remark“Magic Cool Zone” damperR-Fan
R-Fan
“Select”
Close
Close
“Off”
Open
After 2min open
from R-Fan off,
and then close
CloseOFF
CloseCloseCloseON
“Meat”“Fish”“Vegetable”
Condition
“Produce”
“Fish”
“Meat”
Reference
※Initial power input display ⇒ Fahrenheit degree “ ℉”
※To change display for Celsius degree (℃) or Fahrenheit degree (℉)
⇒ Push “select” button 15 seconds