en-us Installation and connection
8
Align refrigerator compartment doors
Aligning the vertical gap of the doors:
Note: Remove any items contained in the doors.
1. Remove T20 screw and cover cap on the door
hinge.
2. Loosen the safety screw.
9 CAUTION
Do not remove the safety screw.
3. With the door closed, turn the adjustment screw
until the desired position is reached.
– To move the upper end of the door outwards,
turn clockwise.
– To move the upper end of the door inwards,
turn counterclockwise.
4. Close the door to check the position and correct
if necessary.
5. Tighten the safety screw again.
6. Fit the cover cap and screw in T20 screw again.
To Next Page
Loading...
Need help?
General
