Installation and connection en-us
9
Aligning the horizontal gap between the doors and
drawer:
9 CAUTION
To avoid damaging the appliance, move the
right-hand door down if the top of the door pillar
interferes with the housing.
Note: Remove any items contained in the doors.
1. Open the door and drawer.
2. Lift the door and insert a screwdriver into the door
hinge from below.
3. Push up the adjustable part and turn by 60° until
the desired position is reached.
– The door height can be set at 2 levels,
adjusted by 1/16" (1.6 mm) in each case. The
higher level is followed by the lower. The
adjustable part engages as soon as a position
is reached.
– To move the door up, turn clockwise.
– To move the door down, turn
counterclockwise.
4. Close the door and drawer to check the position
and correct if necessary.
To Next Page
Loading...
Need help?
General
