SLOT
SLOT 2
Open 3.7 - 5.0 VD
C
Normal 2.0 - 3.0 VDC
Short 0.0 - 1.3 VDC
ETHERNET
100
BASE-T
LINK
USB
COMMU
NICATION M
ODULE 1
C
OUTPUT
B
SDI2
Device Bu
s
R Y G B
ON-BOARD POINTS
1 COM 2
3 COM
4
5
COM
6
7 COM 8
1 k
End of Line Resistor
s
OUTPUT A
OUTPUT A
OUTPUT A
18 VAC
BATTERY
AUX
- 12V +
AUX PWR
COM
DR
Y
J
umper Under Cover
ʊ
Communication Devices
Quick Start Guide
B5512/B4512 Control Panel
1
= PC direct, connect using AutoIP (Wi-Fi off, wait 2 min)
2
= PC direct, connect using Male A to Male A USB cable
On-board Inputs and Outputs
SDI2 Specifi cations
• Unshielded, 4 conductor, 22-12 gauge cable
• Maximum cable length 1000’ single run, 7500’ system total
• Allows a combination of home run, daisy chain and T-tapping wiring confi gurations
SDI2 Device Type Options
Device Type Part # Description ISRG #
Maximum #
of Devices
Address NotesB5512 B4512
Keypad B920 2-line, LCD 9.1.1
8* 8*
01...08
Similar device
types must use
different
addresses.
Different device
types may use
the same
address.
* Maximum of 8
keypads and 1
RF receiver per
system.
B930 5-line, ATM 9.1.2 01...08
I/O Expander B208 8-input 13.1 4 2 01...08
B308 8-output 11.1 5 3 01...08
RF Receiver
B810 Bosch RADION 14.1
1* 1*
1
B820 Inovonics 14.2 1
Power Supply B520 12V DC, 2A 6.3 4 2 01...04
B10 Enclosure
B11 Enclosure
Need more help?
For detailed instructions, refer to the Installation and
System Reference Guide chapter number (ISRG #5.2 )
included on the CD provided with the control panel.
Control Panel Mounting Locations
Attaching Mounting Clips
Technology
Location
ISRG
#
Terminal Description Specifi cation
18VAC
Transformer 18V AC 22VA Plug-in
Earth Ground Cold water pipe, or similar
+ BAT - Battery 12V DC 7Ah
NO C NC Output A Switched AUX, COM, or Dry
COM AUX Aux Power 12V DC, 800mA
R Y G B SDI2 Bus
Keypads, SDI2 devices, terminal
and Quickconnect in parallel
1 COM 2 Alarm Inputs 1k Ohm EOL
TMPR Tamper Optional tamper switch
B C Outputs B, C
Open collector, 50mA,
active low
RESET Reset Switch
Hold 5 seconds to enter or
exit service mode
Heartbeat
Slow =normal, Rapid=service
mode
MODULE 1 Plug-in Communication module options
Reporting
Text Messages
Remote RPS Programming
Local RPS Programming
iOS Remote Security App
Ethernet On-board 7.5
Cellular
B440
Plug-in
8.2
Telephone
B430
Plug-in
7
USB On-board 3.3.8
Transformer
2
1
To Next Page
Need help?
General
