13
Ovenware test
Do not turn on the appliance unless there is food inside.
The following ovenware test is the only exception to this
rule.
Perform the following test if you are unsure whether your
ovenware is suitable for use in the microwave:
1.
Heat the empty ovenware at maximum power for ½ to
1 minute.
2.
Check the temperature occasionally during that time.
The ovenware should still be cold or warm to the touch.
The ovenware is unsuitable if it becomes hot or if sparks
are generated.
Before Using the Appliance for the First Time
▯ Appliance must be properly installed by a qualified
technician before use.
▯ Remove all packing materials from inside and outside
the appliance.
▯ While cool, wipe with a clean, damp cloth and dry.
▯ There may be a slight odor from your new appliance;
this is normal and will disappear after a short time.
▯ Optimum cooking results depend on proper cookware
being used.
▯ Read and understand all safety precautions and Use
and Care Manual information.
Execute the following sections prior to operating:.
The appliance must be completely fitted and connected.
Cleaning accessories
Before using accessories for the first time, thoroughly
clean them with hot soapy water and a soft dish cloth.
Applying the program label
Apply the included program label in the desired
language to the lower frame of the appliance cavity, as
indicated on the leaflet that carries the label.
Operation
Setting the clock
The clock can be set in 12-hour mode.
1.
Touch Clock once.
2.
Enter the time using the number keys.
Example: To set the clock to 12:41 type in 1 2 4 1.
3.
Touch Clock to confirm.
The time of day is displayed.
Setting the Kitchen Timer
You can set a timer value of up ot 99 minutes and
99 seconds.
1.
Touch Kitchen Timer.
The  symbol lights up and ‹‹:‹‹ is blinking.
2.
Enter the desired time using the number keys.
3.
Touch Kitchen Timer to confirm.
The Kitchen Timer starts counting down.
Once the set time has elapsed 4 beeps will sound. To
stop the beep, touch Kitchen Timer.
To cancel the kitchen timer, touch Kitchen Timer again
or open the appliance door.
Operating the Ventilation Fan
The Vent feature moves steam and other cooking vapors
from the cooking surface of the range below the
appliance.
You can set four different vent speeds.
Set the vent feature by touching Vent (high/low). The
ventilation symbol ¾ will light up on the display.
Note: If the temperature gets too hot around the
appliance, the fan of the vent feature will automatically
turn on at the lowest setting to cool the appliance. The
fan will automatically turn off when the internal parts are
cool. When this occurs, the vent cannot be manually
turned off.
Vent level Touch Vent
(high/low) key
Display
4 (high) once
•‚
3 twice
2 3 times
1 (low) 4 times
–‹
OFF 5 times OFF
To Next Page
Loading...
