2
TOOLS NEEDED
Hammer Hole Saw
Pipe Wrench
Tape Measure
Slot Screwdriver
Phillips Screwdriver
T-20 Screw-
Wire Cutter
Wire Stripper
Drill
Level
Adjustable Wrench
Electrical Supply Cable
- Minimum #14 AWG, 2 conductor, 1 ground, insulated
copper conductors rated 75°C or higher.
Hot Water Supply Line - Minimum 3/8” O.D. copper tubing or metal braided
dishwasher supply line.
Shut-off valve and fittings appropriate for hot water supply line (copper tubing/
compression fitting, or braided hose).
90° elbow with 3/8” N.P.T. male threads on one leg, and sized to fit your water supply
line (copper tubing/compression fitting, or braided hose) on the other leg.
Teflon brand tape or other pipe thread compound to seal plumbing connections.
UL listed conduit connector or strain relief.
MATERIALS NEEDED
(Additional materials may be required to comply with local codes.)
Tools and Materials Needed
To Next Page
Loading...
