© All rights with Robert Bosch GmbH, also for the case of protected rights applications
EN_User_documentation_Instructions_for_controlling_the_Logamatic_5000_controller_series_via_Modbus_TCP_I
P_20210203.docx | 10.02.2021
1. General information about the control of the
Logamatic 5000/Control 8000 controller series
via Modbus TCP/IP
If you want to control the controller from a building management system (BMS) via
Modbus TCP/IP, connect the network interface 1 (LAN 1) of the controller (see Fig-
ure 1-1: Module BCT 531 - Representation of the available interfaces) to your ma-
chine network, in which the BMS is also located, using a network cable. You can
then start up the controller properly (see the documentation "Service manual for the
specialist - Logamatic 5311/Control 8311" or "Service manual for the specialist -
Logamatic 5313/Control 8313").
Figure 1-1: Modul BCT 531/BCT 831 – Representation of the available interfaces
To Next Page
Loading...
