© All rights with Robert Bosch GmbH, also for the case of protected rights applications
EN_User_documentation_Instructions_for_controlling_the_Logamatic_5000_controller_series_via_Modbus_TCP_I
P_20210203.docx | 10.02.2021
Figure 2-2: Overview with button to settings menu
Here you switch to the menu “Connectivity”
Figure 2-3: Settings Menu
In the following you have to make some settings for the Modbus TCP/IP communi-
cation at the controller. In particular, you must pay attention to the settings shown in
bold, which may differ from the factory settings in your control device:
To Next Page
Loading...
