8 | Appliance details
Greentherm6 720 805 440 (2014/11)
3.3 Unpacking the heater
Before installing the unit, be certain you have the correct heater for
your type of Gas - Propane or Natural Gas. Identification labels are
found on the shipping box, and on the rating plate which is located on the
right side panel of the cover.
Fig. 2 Rating plate
[A] Serial number
[B] Type of gas
3.3.1 The box includes
• Greentherm water heater
• Bracket for wall hanging the heater
• Exhaust vent adaptor (with 4 screws and gasket provided)
• Combustion air inlet adaptor (with 3 screws and gasket provided)
• Installation manual (manual can be downloaded at www.bosch-
climate.us)
• Product registration card
• Energy Guide label
Please complete and return the enclosed product registration card.
The Greentherm is not approved or designed for:
• Manufactured (mobile) homes, boats or any mobile installation.
(Modular homes are acceptable for installation).
• Use above 8000 ft A.S.L. altitude (see page 22).
• Outdoor installation without installation of Outdoor kit (BTOK):
Outdoor installations in areas where annual minimum
temperatures are below 15 °F.
• Applications where inlet water temperature is higher than
140 °F (60 °C). In these applications a 3 way valve or
thermostatic mixing valve must be installed to prevent inlet
water temperatures > than 140 °F (60 °C).
3.3.2 Remove front cover
▶ Loosen the two Phillips head screws located on bottom rear of cover.
Fig. 3 Loosen the two screws
▶ Lift front cover panel upward and remove.
Fig. 4 Remove the front cover
To Next Page
Loading...
