Bosch Calais USB80 - Setting Button Functions (KEY PRG); Traffic Information; Switching Traffic Information Priority On;Off

48 | en
7 620 000 130 - 133 | 10.2010 Robert Bosch Car Multimedia GmbH
Radio operation | Traffic information
f Press the MENU 7 button to open the
menu.
f Press the MENU 7 button repeatedly
until "HCUT" appears on the display, along
with the current setting of "OFF", 1 or 2
(strength of the interference level cut).
f Turn the volume controller
1
to the left
or right in order to adjust "HCUT" or to
turn it off.
f Press the MENU
7
button, repeatedly if
necessary, to close the menu.
Setting button functions ( KEY PRG )
You can set the short press function of the
and
8
buttons in radio operation. The
following settings are available:
f AUTOSEEK: Automatically search for the
next receivable station.
f MANSEEK: Manually alter the frequency in
steps.
f PRSTSCAN: Sample the stations stored in
the current memory bank.
f BANDSCAN: Sample receivable stations in
the current waveband.
f If necessary, first switch to FM radio
operation.
f Press the MENU 7 button to open the
menu.
f Press the MENU 7 button repeatedly
until "KEY PRG" appears in the display.
f Turn the volume controller
1
to the left
or right in order to change between the
settings.
f Press the MENU
7
button, repeatedly if
necessary, to close the menu.
Traffic information
Switching traffic information prior-
ity on/off
To switch the priority for traffic information on
or off in any operating mode,
f Press the TA = button.
Note:
This function is only available in the
CD, USB and AUX operating modes if
the FM waveband was tuned to last.
The priority for traffic announcements is
activated if the display shows the TA symbol.
As soon as the device receives a traffic
announcement, it is switched through. The
display shows "TRAFFIC" for the duration of
the announcement.
Note:
You will hear a warning beep,
f if you leave the reception area of
the selected traffic information
station while you are listening to
the traffic radio station or a CD,
and the automatic search which
then follows fails to find a new
traffic information station.
f if you retune the radio from a
traffic information station to a
station that does not broadcast
traffic information.
If you hear the warning beep, you can
either switch off traffic information
priority or tune into a station that
broadcasts traffic information.
02_Calais USB_en.indd 48 26.10.10 15:18