To Next PageTo Next PageWhat to do if outdoor or indoor unit of my Bosch CLL5000 W 28 E Air Conditioner is not working?
If your Bosch Air Conditioner's outdoor or indoor unit isn't working, first check the power connection and power on the indoor unit. Also, check the RCD or fuse, as it might have tripped.
How to fix low output from Bosch CLL5000 W 28 E indoor unit?
If the output of your Bosch Air Conditioner's indoor unit is too low, it could be due to a soiled heat exchanger in either the outdoor or indoor unit; clean it. Another cause might be a lack of refrigerant. In that case, check the tightness of the pipes and reseal if required, then refill the refrigerant.
Why does my Bosch CLL5000 W 28 E Air Conditioner outdoor or indoor unit start and stop continuously?
If your Bosch Air Conditioner's outdoor or indoor unit starts and stops continuously, there could be several reasons: * Insufficient refrigerant: Check the tightness of pipes, reseal if needed, and refill refrigerant. * Too much refrigerant: Remove refrigerant using a refrigerant recovery unit. * Moisture or impurities in the refrigerant circuit: Evacuate the refrigerant circuit and fill with new refrigerant. * Voltage fluctuations: Install a voltage regulator. * Defective compressor: Replace the compressor.
General| Brand | Bosch |
|---|---|
| Model | CLL5000 W 28 E |
| Category | Air Conditioner |
| Language | English |
Defines signal words (DANGER, WARNING, CAUTION, NOTICE) and info symbol for risks.
Instructions for qualified persons, intended use, and refrigerant dangers.
Notes on figures and model variations in instructions.
States compliance with Eurasian Customs Union requirements and EAC marking.
Lists items included in the product package, keyed to Figure 1.
Details dimensions and clearance requirements for units and pipes.
Safety precautions before starting installation, like checking for damage.
Specifies conditions for indoor and outdoor unit installation sites.
Procedures for installing the indoor and outdoor units.
Details on connecting refrigerant and condensate pipes.
Guidelines for safe and correct electrical wiring.
A checklist for verifying all installation steps are completed.
Procedures for testing cooling and heating modes.
Instructions for presenting the system to the customer.
Lists error codes and their possible causes and remedies.
Addresses issues without error codes, listing causes and remedies.
