16 | en
7 620 230 020 | 08.2017 Robert Bosch Car Multimedia GmbH
Charging hand microphone
Charging the hand
microphone
If you use the optional charging station you can
charge the hand microphone in it.
The charging station includes a voltage
protection system that prevents short-circuits,
overheating and the charging of conventional
batteries.
Notes:
Make sure that the batteries supplied
with the charging station are inserted
into the hand microphone. Conven-
tional batteries will not be charged.
f Insert the hand microphone into the
charging station, with the handle
downwards.
Notes:
f When inserting, please make
sure that the recess at the
bottom end of the hand
microphone is aligned in such a
way that the charging contacts
reach the correct position.
f The display 6 and LED 8 of
the hand microphone are
deactivated for as long as it is in
the charging station.
The green LED on the charging station
indicates the charge status:
LED Charge status
Flashing
Batteries are being charged
Lit continu-
ously
Batteries are fully charged
Fast
flashing
Fault detected:
f Conventional batteries
inserted
f Batteries short-circuited
f Overheating
f Damaged batteries
(cannot be fully charged)
Notes:
f The hand microphone is
switched on automatically when
you take it out of the charging
station.
f You can leave the hand micro-
phone in the charging station
when it is fully charged. The
charge of the hand microphone
is then automatically kept up
(trickle charging).
f Charging the hand microphone
will only begin if the charge
capacity is less than 80% when
it is inserted.
E_02_BA_WMS_en.indd 16 29.09.17 13:45
To Next Page
Loading...
