en | 43
7 620 210 016 | 11.2013Robert Bosch Car Multimedia GmbH
en
Tone
Tone
Adjusting the treble (TREB), middle
(MID) and bass (BASS)
f Press the AUD ; button to open the
menu.
f Press the AUD ; button repeatedly until
“BASS”, “MID” or “TREB” appears on the
display along with the current setting.
f Turn the volume control
1
to the left or
right in order to set the bass, middle or
treble levels to between +7 and -7.
In order to leave the menu
f press the AUD ; button, repeatedly if
necessary.
Adjusting the left/right volume
balance (BAL) and the front/rear
balance (FAD)
Note:
The “FAD” adjustment is only
available when an external amplifier
is connected.
f Press the AUD ; button to open the
menu.
f Press the AUD ; button repeatedly until
"BAL" or "FAD" appears on the display
along with the current setting.
f Turn the volume control
1
to the left or
right in order to set the volume balance to
between +10 and -10.
In order to leave the menu
f Press the AUD ; button, repeatedly if
necessary.
Switching the loudness (LD) on
and off
f Press the AUD ; button to open the
menu.
f Press the AUD ; button repeatedly until
"LD" appears on the display, along with
the current setting, "ON" or "OFF".
f Turn the volume control
1
to the left or
right in order to switch the loudness on or
off.
In order to leave the menu
f Press the AUD ; button, repeatedly if
necessary.
Resetting the tone
You can reset all the tone adjustments to their
factory default settings.
f Press the AUD ; button to open the
menu.
f Press the AUD ; button repeatedly until
"RESET N" appears in the display.
f Turn the volume control
1
to the right in
order to select "RESET Y".
After about 2 seconds all the tone adjustments
will be reset.
In order to leave the menu
f Press the AUD ; button, repeatedly if
necessary.
Note:
You can reset the tone adjustments at
any time by holding down the AUD
; button for longer than 2 seconds.
This resets all tone adjustments for
the audio source being used at the
time.
02_CR24_en.indd 43 20.11.13 16:54
To Next Page
Loading...
