en
40
Fault Possible cause Remedial action
Floor of the refrigerator
compartment is wet.
The condensation channels
or condensation drainage
pipe are blocked.
Clean the condensation channels
and the outlet (see “Cleaning the appliance”).
Fig. +
Stopper is missing from
the condensation drainage
pipe.
Insert stopper.
The “cool-fresh”
compartment is too warm or
too cold.
The standard setting has
been set too high or too low
(e.g. if there is frost
in the “cool-fresh”
compartment).
Press super button on refrigerator
compartment, Fig. "/6, for 3 seconds until
a beep sounds. Temperature display on
refrigerator compartment 8 flickers.
The temperature in the “cool-fresh”
compartment can be set to be 2 steps warmer
and/or colder. If the bargraph is set to 5, the
“cool-fresh” compartment has a temperature
of almost 0 °C.
Setting 3 – coldest setting
Setting 8 – warmest setting
Change the setting using the temperature
setting button on refrigerator compartment 7.
The set temperature is saved after one minute.
The temperature in
the freezer compartment is
too warm.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
The ventilation openings
have been covered.
Remove obstacles.
Large quantities of fresh
food are being frozen.
Do not exceed max. freezing capacity.
The freezer compartment is
too warm.
Temperature displays,
Fig. "/5 or 8, flash.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
Too much food was placed in
the compartment.
Switch on super freezing before inserting
the food.
To Next Page
Loading...
Need help?
General