Need help?Do you have a question about the Bosch D285 and is the answer not in the manual?
Inspect detector and check LED flash rate for visual confirmation of calibration status.
Test detector sensitivity by applying a magnet to the head and observing LED response.
Measure voltage across EOL resistor to verify detector sensitivity calibration.
Test the thermistor by exposing it to heat to confirm alarm activation.
Inspect detector and check LED flash rate for visual confirmation of calibration status.
Test detector sensitivity by applying a magnet to the head and observing LED response.
Measure voltage across EOL resistor to verify detector sensitivity calibration.
Test the thermistor by exposing it to heat to confirm alarm activation.
General| Brand | Bosch |
|---|---|
| Model | D285 |
| Category | Smoke Alarm |
| Language | English |
To Next Page
