EasyManua.ls Logo

Bosch Dover USB40/80 - Tone Settings; Treble and Bass Adjustment; Volume Balance (BAL;FAD); Resetting Tone Settings

Bosch Dover USB40/80
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en | 35
7 620 000 120 - 123 | 10.2010Robert Bosch Car Multimedia GmbH
en
Tone
Adjusting the treble (TREB) and
bass (BASS).
f Press the AUD 9 button to open the
menu.
f Press the AUD 9 button repeatedly until
"BASS" or "TREB" appears on the display
along with the current setting.
f Turn the volume controller
1
to the left
or right in order to set bass or treble levels
to between +7 and -7.
In order to leave the menu
f press the AUD 9 button, repeatedly if
necessary.
Adjusting the left/right volume
balance (BAL) and the front/rear
balance (FAD)
f Press the AUD 9 button to open the
menu.
f Press the AUD 9 button repeatedly until
"BAL" or "FAD" appears on the display
along with the current setting.
f Turn the volume controller
1
to the left
or right in order to set the volume balance
to between +10 and -10.
In order to leave the menu
f Press the AUD 9 button, repeatedly if
necessary.
Note:
The "FAD" adjustment is only
available on the
7 620 000 120 / 122 devices.
Switching the loudness (LD) on
and off
f Press the AUD 9 button to open the
menu.
f Press the AUD 9 button repeatedly until
"LD" appears on the display, along with
the current setting, "ON" or "OFF".
f Turn the volume controller
1
to the left
or right in order to switch the loudness on
or off.
In order to leave the menu
f Press the AUD 9 button, repeatedly if
necessary.
Resetting the tone
You can reset all the tone adjustments to their
factory default settings.
f Press the AUD 9 button to open the
menu.
f Press the AUD 9 button repeatedly until
"RESET N" appears in the display.
f Turn the volume controller
1
to the right
in order to select "RESET Y".
After about 2 seconds all the tone adjustments
will be reset.
In order to leave the menu
f Press the AUD 9 button, repeatedly if
necessary.
Note:
You can reset the tone adjustments at
any time, by holding down the AUD ;
button for longer than 2 seconds.
This only resets the treble and bass
adjustments for the audio source
being used at the time.
Tone
02_Dover USB_en.indd 35 21.10.10 18:10

Table of Contents

Related product manuals