English 4
Before You Begin
Overview
Proceed to the sections that follow for step-by-step instructions.
Tools and Parts Needed • Range Power Supply Cord Kit (240V -30 Amp)
Note: Not necessary for Canadian installations; Canadian units are shipped
with the power cord already installed.
• Measuring Tape
• Phillips Head Screwdriver
• 1-1/4” (31.8 mm) Wrench
•Pencil
• T-20 Torx Screwdriver
• Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on
mounting surface)
•Level
• Drill and Drill Bit
• Soapy Water
• Pipe Wrench
• Teflon Tape
• Channel Lock Pliers
• Gas Leak Test Solution
• Gas Supply Line
• Gas Shut Off Valve
• Safety Gloves and Goggles
• Tape (Optional)
• Cloth or Cardboard (Optional - to Protect Floor)
Additional Parts Needed For
Hard Wire Installations
• Flexible Conduit
• Torque Wrench
• Note: Power Supply Cord Kit Not Necessary For Hard Wire Installations
Installation
Table 1: Overview
Step Task
1.
Preparation
2.
Apply Foam Tape
3.
Install Backwall Trim (Optional)
4.
Connect Electric
5.
Connect Gas Supply
6.
Test for Gas Leaks
7.
Test the Installation
To Next Page
Loading...
