en Troubleshooting
10
Replacing the odour filter
1.
Open the glass plate.
2.
Remove the grease filters.
You can find information about removing the grease
filters in the operating instructions for your appli-
ance.
3.
Position the large odour filters at the bottom and
swing them up .
The foam must be compressed when you insert it.
4.
Position the small filter at the back and swing it
up .
a The odour filters have been installed.
5.
Install the grease filters.
6.
Close the glass plate.
Troubleshooting
12 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING‒Risk of injury!
Improper repairs are dangerous.
▶ Repairs to the appliance should only be carried out
by trained specialist staff.
▶ If the appliance is defective, call Customer Service.
→"Customer Service", Page11
WARNING‒Risk of electric shock!
Improper repairs are dangerous.
▶ Repairs to the appliance should only be carried out
by trained specialist staff.
▶ Only use genuine spare parts when repairing the
appliance.
▶ If the power cord of this appliance is damaged, it
must be replaced by trained specialist staff.
12.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your room or other appliances are working.
The plug connection to the glass plate has not been established correctly.
▶
Check the plug connection to the glass plate.
→"Installing the appliance", Page18
To Next Page
Loading...
