To Next PageTo Next Page
Need help?Do you have a question about the Bosch EasyImpact 600 and is the answer not in the manual?
General| Power | 600 W |
|---|---|
| Max Drilling Diameter in Concrete | 12 mm |
| Max Drilling Diameter in Wood | 25 mm |
| Max Drilling Diameter in Steel | 10 mm |
| Weight | 1.7 kg |
| Cable Length | 2.5 m |
| Impact Rate | 45, 000 bpm |
| Chuck | 13-mm keyless chuck |
Read all safety warnings, instructions, illustrations and specifications. Failure to follow may result in electric shock, fire and/or serious injury.
Keep work area clean and well lit. Cluttered or dark areas invite accidents. Do not operate in explosive atmospheres.
Power tool plugs must match the outlet. Avoid body contact with earthed surfaces. Do not expose to rain or wet conditions.
Stay alert, watch what you are doing. Use personal protective equipment. Prevent unintentional starting.
Do not force the power tool. Use the correct power tool for your application. Maintain power tools and accessories.
Wear ear protectors when impact drilling. Use the auxiliary handle. Hold by insulated gripping surfaces.
Never operate at higher speed than the drill bit's maximum speed rating. Apply pressure only in direct line with the bit.
Switch off if the application tool becomes blocked. Hold securely. Secure the workpiece.
The power tool is intended for impact drilling in brick, concrete and stone, as well as for drilling in wood, metal, ceramic and plastic.
The numbering of the product features refers to the diagram of the power tool on the graphics page.
Typically, the A-weighted noise level is 91 dB(A) sound pressure level. Wear hearing protection!
Pull the plug out of the socket before carrying out any work. Implement additional safety measures to protect the operator.
Do not operate without the auxiliary handle (8). Adjust to any of 12 positions for a safe work posture.
Use the depth stop (9) to set the required drilling depth X. Ensure fluting faces downwards.
Pay attention to mains voltage. Power tools marked 230 V can operate with 220 V.
Use switch (7) to change direction. Not possible while switch (6) is pressed.
Set selector switch (4) to 'drilling' or 'impact drilling' symbol. Switch clicks into place.
Press and hold switch (6) to start. Use lock-on button (5) to lock. Release switch (6) to stop.
Adjust speed/impact rate by varying pressure on switch (6). Light pressure = low speed.
Pull plug before work. Apply tool to screw/nut when off. Operate at max speed to cool down.
