Bosch EHP 6.5 AA - Maintenance Procedures; Before Performing Maintenance; Cleaning Filters and Unit; Removing and Reattaching Panels

GB-13
ENGLISH
CLEANING THE UNIT AND THE REMOTE
CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It can
cause electrical shock or equipment damage.
• Do not use hot water, thinner, abrasive powders or
strong solvents.
MAINTENANCE
BEFORE PERFORMING MAINTENANCE
Be sure to turn off the circuit breaker before performing
any maintenance.
1
Turn off the unit.
2
Wait 15 seconds or more after the open
panel is completely closed, and turn off
the circuit breaker.
CLEANING THE FILTERS
The air lters should be cleaned every two weeks.
1
Turn off the unit.
2
Remove the lters.
1 Lift the lter cover.
2 Push the air lters up slightly to unlock them.
3 Pull the air lters down to remove them.
3
Take off the air purifying lters from the
air lters.
4
Clean the lters.
Use a vacuum cleaner to remove dust. If the
lters are dirty, wash them with warm water and
a mild detergent. Dry lters in the shade before
reinstalling.
5
Reinstall the air purifying lters.
6
Reinstall the lters.
1 Reinstall the lters in the original positions.
2 Close the lter cover.
2
1
1
2
3
2
1
1
2
Filter cover
Open panel
REMOVING THE OPEN PANEL
The open panel can be removed for cleaning.
1
Push the release button and open the
lower part of the open panel.
2
Lift the open panel up slightly and
remove it.
ATTACHMENT
1
Hook both tabs on the shaft.
There is a shaft on each end of the unit.
2
Close the open panel.
Push the arrow-marked points on the open
panel until it clicks.
After attachment, be sure to close the open panel
rmly.
Tab
Shaft
Open panel
Release
button
Acceptable
Unacceptable
EHP6.5_AA_multi_TINSEA825JBRZ.indd 13 2013/7/6 13:35:34