38 39
7.2 Wall mounting
When choosing a mounting location and when drilling, pay attention to
potential electrical cables and/or supply lines that could be behind the
wall.
On the base of the Gateway there
are two recesses for the screw heads,
which enable the Gateway to be fitted
to the wall. Please use the enclosed
plugs and screws to mount it if re-
quired.
▶ Mark two hole positions 4.8 cm
apart at the desired position on
your wall
▶ Drill the holes and insert the plugs
▶ Drive the screws into the plugs
▶ Position the Gateway over the
screws and slide down until it locks
into place
Base
Top
To Next Page
Loading...
