Bosch FCP-O320 - Test Procedure for Detectors Without C-Sensor; Warranty; Repair; Disposal

Conventional Automatic Fire Detectors Maintenance and Service | en 27
Bosch Sicherheitssysteme GmbH
User manual
2021.03 | 11 | F.01U.004.377
7.3 Test Procedure for Detectors without C-Sensor
1. Position the Smoke Detector Tester on the detector.
2. Spray aerosol (1 to 2seconds).
Do not remove the test device from the detector; the Osensor triggers only approx.
30seconds after the application of the test aerosol.
3. Reset detector.
This switches the detector to revision mode.
4. The thermal sensor of the FCP‑OT320/FCP‑OT320‑R470 and all heat detectors is tested
with the test device for heat detectors.
7.4 Warranty
Defective detectors are exchanged free of charge in the case of a claim under the warranty.
7.5 Repair
In the event of a defect, the entire detector is exchanged.
7.6 Disposal
Unusable electrical and electronic devices/modules must not be disposed of
with normal household refuse. They must be disposed of in compliance with
the applicable regulations and directives (e.g. WEEE in Europe).
FCP-OC320 Packaging Film
The packaging bag used for multisensor detectors with C sensor consists of tear-resistant PE-
ALU laminated film and may be disposed of with the household refuse.
Defective detectors are exchanged and should be disposed of in accordance with statutory
regulations.
7.7 Additional Documentation
i
Notice!
Refer to the technical documentation for this product available for download at
www.boschsecurity.com.