Bosch Fireray 50 - 11 Appendices; Installation Protocol

PI - 34.85
Product Information Linear Smoke Detector Fireray 50/100RV
601-F.01U.002.705
A1.en / 29.12.2004
ST-FIR/ PRM1/ zab
Seite 20 von 22
11. Appendices
11.1.Installation protocol
Installation company:
Type of object:
Installation location:
Installation date:
Total number of all linear detectors:
Detector version:  Fireray 50RV
 Fireray 100RV
Detector – reflector distance: _________ m
Distance of the detector axes to one
another
_________ m
Mounting height _________ m
Mounting surface (e.g. masonry/rein-
forced concrete/steel beams/wood/etc.)
Serial number(s):
Reflector size:  1 x (10 x 10 cm)
 4 x (20 x 20 cm)
Supply voltage: _________ V
Correct mechanical adjustment of
transmitter (when gentle pressure is
applied to the detector housing from
the left/right/top/bottom, the yellow LED
lights up initially):
 yes  no
Alarm triggered with absorption film
35% - 50% tested:
 yes  no
Fault triggered by disruption of IR
beam tested:
 yes  no
DIP switch settings:
on
off
1234
Comments (environmental conditions, e.g. dust, humidity, temperature etc.)
Installation tested on: ____________ by: ___________________________