PI - 34.85
Product Information Linear Smoke Detector Fireray 50/100RV
601-F.01U.002.705
A1.en / 29.12.2004
ST-FIR/ PRM1/ zab
Seite 4 von 22
3. Features
Compact housing with integrated transmitter, receiver, and control unit
Detector ranges:
- Fireray 50RV 5 m to 50 m
- Fireray 100RV 50 m to 100 m
Side detection breadth of 7.5 m on both sides of the beam center line (according
to VdS max. 7 m on both sides of the beam center line)
Easy to mount; cost-effective retro operation using prism reflectors
Areas of application:
Historical buildings, churches, museums, shopping malls, factory halls,
warehouses, power plants, contaminated environments, etc.
The prism reflectors permit angle deviations up to 5 from the center line without
signal deterioration.
With a max. mounting height of 16 m, the monitored room volume can be up to
22,400 m
3
Very low current consumption
Operating voltage 10 V DC to 30 V DC
Adjustable alarm thresholds/sensitivity
Alarm storage or automatic reset possible
Alarm output in the form of a potential-free, latching dry relay contact
Electronic help for detector alignment and automatic detector calibration procedure
Automatic compensation for contamination
LED indicators for:
- Alarm (red)
- Malfunction (yellow)
- Operating indicator (flashes yellow once in every 10 s)
- End of readjustment due to contamination/aging (flashes yellow once every 2 seconds)
Can be connected to the local security network via a control coupler (NSB 100)
Cross zoning possible with connection using a NBK 100 LSN and two NSB 100 LSN
Fulfills the following regulations:
- BS 5839 Part 5
- EN 54 Part 12
- VdS approval number: G 203070
To Next Page
Loading...
