Wiring detectors (optional)
Notice!
The cable for wiring the detectors must not touch the antenna.
If desired, you may wire up to 5 detectors with a two-core cable.
For each detector to be connected perform the following steps,
observing the polarity shown in the graphic.
1. Guide the cable through the opening of the base and
secure the cable with cable ties. Leave enough cable length
to perform a battery change later.
2. Strip the wire ends for about 6 mm.
5.5
FERION 3000 OW Notices | en
31
Bosch Sicherheitssysteme GmbH 2014.09 | 4.3 | F.01U.249.486
To Next Page
Loading...
