-8-
Troubleshooting
Problem Corrective Measure
External USB device
cannot be charged using
the USB port.
Check that the battery pack is charged.
Connect the charging cable of the external USB device to
the USB port on the battery controller. Activate the battery
controller by pressing On button.
Check that your device does not require any more than the
following...
a) when one USB port is used:
5V DC, 2.4 Amp Maximum Output
b) when two USB ports are used:
5V DC, 1.2 Amp Maximum Ouput
Unfortunately, not all devices can be tested for compatibility
and your device may not be compatible.
Heated jacket heating
element does not heat up.
Check that the battery pack is charged.
Connect the cable of the heating element to the port on the
battery controller. Activate the battery controller by pressing
On button.
To reduce the risk of injury,
always unplug the battery
controller and remove the battery pack
before performing any maintenance. Never
disassemble the battery pack or battery
controller. Contact a Bosch service facility
for all repairs.
Keep the battery controller, battery and
charger clean at all times.
Do not immerse the battery controller,
battery and charger into water or other
fluids.
Wipe off debris using a moist and soft
cloth. Do not use any cleaning agents or
solvents.
The battery is not serviceable and should
be repaired by an authorized service
center.
!
WARNING
Maintenance
To Next Page
Loading...
