To Next PageTo Next Page
Need help?Do you have a question about the Bosch GBH2-28L and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | GBH2-28L |
| Category | Rotary Hammer |
| Language | English |
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug in any way.
Stay alert, watch what you are doing and use common sense when operating a power tool.
Do not force the power tool. Use the correct power tool for your application.
Wear ear protectors. Exposure to noise can cause hearing loss.
GFCI and personal protection devices like electrician's rubber gloves and footwear will further enhance your personal safety.
Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant.
Accessories may be hot after use. Avoid contact with skin and use proper protective gloves or cloth to remove.
The tool must be supported with the auxiliary handle, which can be swiveled 360°.
Your drilling depth can be pre-set and/or repeated by using the depth gauge.
Your tool is equipped with a variable speed trigger switch. The tool speed can be controlled from the minimum to the maximum nameplate speed...
This tool is equipped with a rotating brush reversing system. This results in longer brush life...
The tool has an internal preset clutch. The clutch is set such that sufficient force is transmitted to the bit...
The rapid shut-off feature enables better control and improves user's comfort.
The selector dial allows the tool to be set for various drilling/hammer drilling applications.
Adjusting the Vario-Lock: The vario-lock can be set in any one of thirty-six (10° increments) positions.
Your tool is equipped with a convenient hook for hanging your tool.
Following a few simple tips will reduce wear on the tool and the chance of injury to the operator.
For selection of dust collection systems and operating instructions, see the Operating / Safety Instructions for 'Dust Extraction'.
Your Bosch tool has been properly lubricated and is ready to use.
The brushes and commutator in your tool have been engineered for many hours of dependable service.
After about 300-400 hours of operation, or at every second brush change, the bearings should be replaced.
To avoid accidents always disconnect the tool from the power supply before cleaning or performing any maintenance.
If an extension cord is necessary, a cord with adequate size conductors that is capable of carrying the current necessary for your tool must be used.
List of standard and optional accessories for the tool.
