-20-
Working without Automatic Levelling
Sequence of
actions
Horizontal line
operation
Vertical line
operation
Point
operation
Indicator 3
for battery
capacity
Indicator 4 for
working without
automatic
levelling
Figure
On/Off switch 2 in position
“ ”
● ●
Cross-line operation
— green red F1
Press button for “line &
point” operating mode
5 once
● — — green red
Press button for “line &
point” operating mode
5 twice
— ● — green red
Press button for “line &
point” operating mode
5 three times
● ●
Cross-line operation
— green red F1
The laser lines flash slowly in the “working without automatic level-
ling” mode.
If during work without automatic levelling you switch to the “working
with automatic levelling” mode (On/Off switch 2 in position “ ”),
the first combination of this mode’s indicators is always activated.
Automatic Levelling
Working with Automatic Levelling (see figures B1–E1)
– Position the measuring tool on a level, firm support or attach it to the
rotating mount 15 and 16.
– For work with automatic levelling, slide the On/Off switch 2 to posi-
tion “ ”.
After switching on, the levelling function automatically compensates
irregularities within the self-levelling range of ±4°. The measuring tool
is levelled in as soon as the laser lines no longer flash.
The laser beam will flash if the automatic levelling is not possible.
To Next Page
Loading...
