10
EURO
•
BA 2 609 931 347
•
GDA 280 E
•
OSW 06/00
•
Text GB
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are strictly
followed. In addition, the general
safety instructions in the enclosed booklet
must be followed. Before using for the first
time, ask for a practical demonstration.
If the cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
The dust that is produced while
working is detrimental to health.
Use dust extraction and wear a
dust mask.
Do not work with materials contain-
ing asbestos.
■ The machine must be used only for dry grinding.
■ Always direct the cable to the rear away from
the machine.
■ Connect machines that are used in the open
via a residual current circuit breaker with a
triggering current of 30 mA maximum. Use
only extension cables that are intended for
outdoor use and are protected against splash
water.
■ When grinding metal, flying sparks are pro-
duced. Take care that no persons are endan-
gered. Because of the danger of fire, no com-
bustible materials should be located in the
vicinity (spark flight zone).
■ Bosch can assure flawless functioning of the
machine only when original accessories are
used.
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the tool is 80 dB (A). The noise level when work-
ing can exceed 85 dB (A). Wear ear protection!
The typical weighted acceleration is 3 m/s
2
.
Noise/vibration information
The machine is intended for sanding and polish-
ing of wood, plastic and metal materials as well
as for painted surfaces.
As a result of its handiness and extensive acces-
sories, the machine can be used for various pur-
poses and is especially suitable for working in
corners, edges and small surfaces as well as for
hard-to-reach places.
Intended Use
For your safety
Operating Controls
1 Vacuum hose*
2 Vacuum connection
3 Thumbwheel for oscillation rate
4 On/Off switch
5 Gripping surface
6 SDS slider
7 Ventilation slots
8 Sanding plate
9 Sanding sheet (standard)*
10 Louver sanding attachment*
11 Sanding sheet for sanding tongue*
12 Velcro material for sanding tongue*
13 Sanding tongue (flat)*
14 Sanding tongue (oval)*
*Accessory
Not all of the accessories illustrated or described are
included as standard delivery.
Delta Sander GDA 280 E
Order number 0 601 294 7..
Rated power input 280 W
Power output 112 W
No-load speed 6 500 - 9 500 min
-1
No-load oscillations 13 000 - 19 000 min
-1
Sanding plate size
(corner to corner) 94 mm
Weight (without access.) Approx. 1.1 kg
Protection class / II
Tool Specifications
GB
To Next Page
Loading...
