12
Changing the filter
!
Please note: Always switch off the appliance before changing the
filter.
Replacing the dust bag
Figure
a)If the dust bag change indicator lights up red continuously when the floor
tool is lifted from the floor and the highest power setting has been
selected, the dust bag must be changed, even though it may not yet be
full. Even if the dust bag is not full, it may still need changing, due to the
type of dust which has been vacuumed.
F
irst check that the nozzle, suction pipe and flexible hose are not
blocked, as this would also lead to the dust bag change indicator being
triggered.
b)The handle can easily be detached from the hose to remove blockages.
Figure
Opening the lid
● Open the lid by moving the locking lever in the direction of the arrow.
Figure
a)Seal the dust bag by pulling the sealing tab, and remove the bag.
b)Insert the new dust bag into the holder up to the stop.
!
Caution: the lid will only close if a dust bag has been inserted.
18
19
20
18
19
20
a
b
To Next Page
Loading...
