Bosch GSR 6-20 TE - Page 7

9
Screw driving drill GSR 6-20 TE GSR 6-25 TE GSR 6-40 TE
Part number 0 60 1 423 7.. 0 60 1 421 7.. 0 60 1 420 7..
Rated power 600 W 500 W 500 W
Output power 310 W 270 W 270 W
No-load speed 0 - 2000 min
-1
0 - 2500 min
-1
0 - 4000 min
-1
Rated speed 0 - 1300 min
-1
0 - 1700 min
-1
0 - 2800 min
-1
Tool holder
1
/
4
" (6.35 mm)
1
/
4
" (6.35 mm)
1
/
4
" (6.35 mm)
Hex. socket Hex. socket Hex. socket
Screw diameter max. 6.3 mm max. 6 mm max. 6 mm
Weight approx. 1.9 kg approx. 1.5 kg approx. 1.5 kg
Safety class / II / II / II
1 Screwdriver blade (bit)
2 Screw depth stop
3 Adjustment collar
4 Belt clip
5 Reversing switch
6 On-Off switch
7 Locking button for On-Off switch
Not all of the accessories illustrated or described
are included as standard delivery.
The machine is intended for the screwing in and
loosening of screws as well as for drilling in wood,
metal, ceramic and plastic.
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the tool is : GSR 20 TE: 82 dB(A); GSR 25 TE:
79 dB(A); GSR 40 TE: 78 dB (A).
The noise level when working can exceed
85 dB (A).
Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
2
.
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are
strictly followed. In addition, the
general safety instructions in the enclosed
booklet must be followed. Before using for the
first time, ask for a practical demonstration.
Before each use of the machine,
check the cable and plug. If dam-
age is detected, do not use the
machine. Have repairs performed
only by a qualified technician.
Never open the machine your-
self.
■ Insert the mains plug only when the machine is
switched off.
■ During pauses in the work, when not in use or
during work on the machine itself (e.g., chang-
ing of the working tools, repairs, cleaning, ad-
justment), pull the mains plug.
■ Do not carry the machine by the cable.
■ Always direct the cable to the rear away from
the machine.
■ Secure your workpiece with clamps.
■ Be careful when screwing in long screws; dan-
ger of sliding off.
■ Place the machine on the screw/nut only when
switched off.
■ Bosch can assure flawless functioning of the
machine only when original accessories are
used.
Tool Specifications
Operating Controls
Use as Intended
Noise/Vibration Information
For your Safety
GB