English - 1
1 Screwdriver attachment (bit)
2 Screw depth stop
3 Adjustment collar
4 Belt clip
5 Lock-on button for On/Off switch
6 On/Off switch
7 Rotational direction switch
Not all of the accessories illustrated or described are
included as standard delivery.
The machine is intended for the screwing in and
loosening of screws. For screws with machine
threads, a low speed setting is required.
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 82 dB (A).
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the en-
closed booklet must be ob-
served.
■ Wear safety goggles.
■ For long hair, wear hair protection. Work only
with closely fitting clothes.
■ If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
■ Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
■ Always direct the cable to the rear away from
the machine.
■ Hold the machine tightly: When driving in
screws, high reaction moments can briefly oc-
cur.
■ Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
■ Always switch the machine off and wait until it
has come to a standstill before placing it down.
■ Never allow children to use the machine.
■ Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
Tool Specifications
Screw driving drill GSR 6-20 TE GSR 6-25 TE GSR 6-40 TE
Order number 0 061 423 7.. 0 601 421 7.. 0 601 420 7..
Rated power [W] 600 500 500
Output power [W] 310 270 270
No-load speed [rpm] 0–2 000 0–2 500 0–4 000
Rated speed [rpm] 0–1 300 0–1 700 0–2 800
Tool holder (Hexagon size)
1
/
4
"
1
/
4
"
1
/
4
"
Screw diameter, max. [mm] 6.3 6 6
Weight (without accessories),
approx.
[kg] 1.9 1.5 1.5
Protection class / II / II / II
Please observe the order number of your machine. The trade names of the individual machines may vary.
Machine Elements
Intended Use
Noise/Vibration Information
For Your Safety
9 • 3 609 929 623 • TMS • 14.03.03
To Next Page
Loading...
