Bosch GTM 12 JL Professsional - Page 45

English | 45
Bosch Power Tools 1 609 92A 0BP | (9.7.13)
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
Always make trial cuts with the mitre angle setting first on
scrap wood.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Ceiling Strips/Mouldings (According to US Standard)
Settings Placed
against the
fence
Lying flat on
the saw table
Bevel angle 0° 45°
Floor strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre angle
45° left 45° right 0° 0°
Positioning of work-
piece
Bottom edge on
saw table
Bottom edge on
saw table
Upper edge against
the fence
Bottom edge
against the fence
The finished work-
piece is located...
... to the left of the
cut
... to the right of the
cut
... to the left of the
cut
... to the left of the
cut
Outer corner Horizontal mitre angle
45° right 45° left 0° 0°
Positioning of work-
piece
Bottom edge on
saw table
Bottom edge on
saw table
Bottom edge
against the fence
Upper edge against
the fence
The finished work-
piece is located...
... to the left of the
cut
... to the right of the
cut
... to the right of the
cut
... to the right of the
cut
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the standard mitre angles
of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
Settings Placed
against the
fence
Lying flat on
the saw table
Bevel angle 0° 33.9°
Ceiling strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre angle
45° right 45° left 31.6° right 31.6° left
Positioning of work-
piece
Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
Bottom edge
against the fence
The finished work-
piece is located...
... to the right of the
cut
... to the left of the
cut
... to the left of the
cut
... to the left of the
cut
Outer corner Horizontal mitre angle
45° left 45° right 31.6° left 31.6° right
Positioning of work-
piece
Bottom edge
against the fence
Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
The finished work-
piece is located...
... to the right of the
cut
... to the left of the
cut
... to the right of the
cut
... to the right of the
cut
52°
38°
52°
OBJ_BUCH-1688-004.book Page 45 Tuesday, July 9, 2013 11:59 AM
Ташев-Галвинг ООД
www.tashev-galving.com