To Next PageTo Next Page
Need help?Do you have a question about the Bosch GCM 12 SD and is the answer not in the manual?
General| Blade Diameter | 12 inches |
|---|---|
| Power Input | 15 amps |
| Weight | 23.5 kg |
| Max. Bevel Angle Left | 47° |
| Max. Bevel Angle Right | 47° |
| Max. Miter Angle Right | 60° |
| No Load Speed | 3, 800 RPM |
| Voltage | 120 V |
| No-load speed | 3, 800 RPM |
| Type | Sliding Mitre Saw |
| Arbor Size | 1 inch |
| Max Cutting Capacity (Vertical) | 120 mm |
| Max Cutting Capacity (Horizontal) | 14 inches |
| Max. Miter Angle Left | 60 degrees |
| Power | 1, 800 W |
| Max. cutting depth at 90° | 120 mm |
| Max. cutting width at 90° | 14 inches |
Covers safe work area practices, electrical precautions, and personal safety during operation.
Details proper tool handling, securing workpieces, and maintenance for safe operation.
Emphasizes lighting, protective gear, and safe electrical connections for mitre saw operation.
Guides on secure mounting, material compatibility, and correct saw blade usage.
Outlines safe sawing practices, keeping hands clear, and avoiding blade obstructions.
Covers symbols for volts, amperes, frequency, power, units of measure, and rotational speed.
Details symbols for fastener types, current types, general warnings, and handling instructions.
Explains machine-specific warnings and saw blade dimension requirements.
Illustrates symbols related to cutting movements, safe transport, and handle adjustments.
Depicts symbols for bevel angle settings, locking mechanisms, and environmental recycling.
Identifies key components of the machine with directional labels (front, rear, left, right).
Describes the tool's purpose and provides noise and vibration information.
Lists technical specifications and identifies the main components of the machine.
A critical reminder to wear ear protection due to noise levels.
Guides on safely transporting and securing the mitre saw for storage or movement.
Provides steps for safely replacing or removing the saw blade.
Details the procedure for correctly installing a new saw blade.
Explains how to connect dust extraction systems for a cleaner work environment.
Covers extending the fence and saw table for improved work piece support and positioning.
Instructions on securely clamping work pieces for accurate cuts.
Guides on setting horizontal mitre angles for various cuts.
Details how to set vertical bevel angles for angled cuts.
Explains how to set specific bevel angles like 0°, 45°, and 33.9°.
Covers adjusting the handle for comfort and the procedure for switching the tool on/off.
Provides general sawing advice, hand placement, and work piece dimension guidelines.
Explains how to perform cuts with and without the slide movement feature.
Details adjusting the depth stop and safely handling special or irregular work pieces.
Guides on replacing table inserts and working with profile mouldings.
Provides specific settings for cutting floor and ceiling mouldings.
Instructions for checking and adjusting the 0° and 45° vertical bevel angle settings.
Details adjusting clamping forces and aligning angle indicators for accuracy.
Covers checking and adjusting the fence for accurate cuts.
Outlines routine maintenance, proper disposal, and service procedures for the tool.
Lists available accessories for the mitre saw.
