English–71 609 929 F67 • (04.10) PS
3 FUNCTION
While reading the operating instruc#
tions, refer to the corresponding illus#
trations of the electro#tool on the front
pages.
Intended Use
The electro#tool is intended as a stationary machine for
performing lengthways and crossways straight cuts in
wood or similar materials.
Also possible are horizontal mitre angles of 52° (left
side) to 60° (right side) as well as vertical bevel angles
of 47° (left side) to 47° (right side).
Noise/Vibration Information
Measured values are determined according to stand#
ard EN 61 029 procedures.
The A#weighted noise levels of the tool are typically:
Sound pressure level: 89,5 dB(A)
Sound power level: 102,6 dB(A)
Measurement uncertainty K = 3 dB
Wear ear protection!
The hand#arm vibration is typically below 2.5 m/s
2
.
Product Specifications
Switch#on actions cause brief drops in the mains volt#
age. For unfavourable mains conditions, interference
with other equipment can occur.
For mains impedance of less than 0.15 Ω, no interfer#
ence can be expected.
Product Elements
The numbering of the machine elements refers to the
illustrations of the electro#tool on the front pages of the
operating instructions.
1 Dust bag
2 Allen key (1.5 mm)
3 Open#end spanner (10 mm, 17 mm)
4 Transport handle (front)
5 Clamp for the handle
6 Lever for adjusting the inclination of the handle
7 Handle
8 Button for unlocking the locking lever 43
*
9 Saw blade
10 Swinging guard
11 Roller
12 Table insert
13 Locking clamp
14 Locking knob for variable mitre angles (horizontal)
15 Lever for mitre angle adjustment (horizontal)
16 Clamping handle for variable bevel angle (vertical)
17 Detents for standard mitre angles
18 Saw table
19 Mounting holes
20 Fence
21 Fence extension
22 Locking knob for the fence extension
23 Quick action clamp
24 Angle indicator (vertical) for the right bevel angle
range
25 Slide rails
26 Cable holder
27 On/Off switch
28 Transport locking pin
29 Adjustment screw for the depth stop
30 Carrying handle (rear)
DualBevel
Slide Mitre Saw
GCM 12 SD
PROFESSIONAL
Order number
0 601 B23 …
… 503
… 508
… 532
… 542
… 537 … 541
Rated input
power
[W] 1 800 1 800 1 450
Voltage [V] 230 240 110
Frequency [Hz] 50 50 50
No load speed [min
#1
] 3 800 3 800 3 700
Tool spindle [mm] 30 25.4 30
Weight
(according to
EPTA Procedure
01/2003)
[kg] 29.1 29.1 29.1
Saw blade ∅ [mm] 305 305 305
Protection class / II / II / II
For maximum work piece dimensions,
see the "Working Instructions" Section
0-45°
To Next Page
Loading...
